11 Instrument Panel Lamps

Lamp
Indicator
Description
Results
Amber Warning Lamp (AWL)
Indicates a fault with the engine controls.
Vehicle can be driven to end of shift. Call for service.
Red Stop Lamp (RSL)
Indicates a major engine fault that may result in engine damage
Engine derate and/or shutdown sequence will be initiated.
Move the vehicle to the nearest safe location and shutdown the engine. Call for service
DPF Regeneration Lamp
Solid yellow indicates a parked regeneration is required.
Blinking yellow, derate, and/or shutdown are possible as soot load continues to increase. Lamp will shut of during regeneration.
<u>Lamp Solid </u> - parked regeneration required.
<u>Lamp Flashing </u> - parked regeneration required immediately.
High Exhaust System Temperature (HEST) Lamp
This is an information indicator. Indicates exhaust temperature is above a preset limit and the unit is operating at low vehicle speed. Lamp flashes once every ten seconds during a parked regen. Lamp is yellow.
Vehicle can be driven.
Malfunction Indicator Lamp (MIL)
Yellow lamp Indicates a failure of an Emission Control device. May illuminate at the same time as the Amber Warning Lamp
Vehicle may be driven to end of the shift. Call for service
Table , Instrument Panel Lamps
Lamp
Indicator
Description
Results
Water in Fuel (WIF) Lamp
Flashes for 5 seconds at the start of every ignition cycle (a bulb check).
Indicates the fuel filter has a high level of water and must be drained.
Light stays lit indicating water must be drained from filter.
Table , Water in Fuel Instrument Panel Lamp
The activation conditions are listed in Table "Lamp Activation Conditions" .
Lamp
Lamp Solid
Lamp Flashing
When a parked regeneration is required immediately (If the lamp flashing is ignored, derate and/or shutdown could occur.
Flashes every 10 seconds during a parked regen
Never flashes
Table , Lamp Activation Conditions