Removal of the Final Filter - Three-Filter System
Removal of the Final Filter - Three-Filter
System - DD Ops
Remove the final filter as follows:
- Using a 36-mm socket, unscrew the final filter cap.
- Pull the cap and final filter straight up and allow the fuel to drain back.
- Remove the final filter (2) from the final filter cap (1)
by placing the filter on a solid surface and apply pressure on the
final filter cap at an angle.
- Discard the filter.
- Inspect inside the housing for any large debris and clean if needed.
- Discard final filter cap seal ring.
Notice: Do not tilt the final filter when removing it from the housing. Possible
damage to the final filter or stand pipe may occur.