Installation of the Water Separator/Coalescer - Three-Filter System
Installation of the Water Separator/Coalescer
- Three-Filter System - DD - Ops #3499
Install the water separator/coalescer as follows:
- Snap a new water separator/coalescer into the Water Separator/Coalescer cap.
- Install a new Water Separator/Coalescer cap seal ring.
- Apply a light coat of petroleum-based lithium grease to
the Water Separator/Coalescer cap seal ring and to the lower seal
(1) on the water separator/coalescer filter.
- Install the water separator/coalescer into the fuel filter module.
- Turn the cap counterclockwise until a "click" sound is made, then turn clockwise and hand tighten.
- Torque water separator/coalescer cap to 55 to 60 N·m (41 to 44 ft·lb).
- Once all required filters have been changed, prime the fuel system. Priming the Fuel System - Three-Filter System.