Windshield Wiper/Washer Controls
Notice: Do not attempt to manually move the windshield wiper arms. Wiper motor damage will occur if the arms are forcibly moved.
The wipers are operated by a rotary dial located at the end of the turn signal lever. See Fig.. There are five delay settings (marked on the dial by lines of increasing length) and two steady speed settings, LO and HI.
Rotate the control dial away from you to turn the wipers on or speed them up.
Rotate the control dial towards you to slow the wipers down or turn them off.
-
Windshield Washer
-
OFF Position
-
Delay Settings
-
Low Speed Setting
-
High Speed Setting
Fig. 1, Windshield Wiper/Washer Controls
Rotating the control dial away from you (counterclockwise) turns the wipers on. If they are already on, rotating the handle further forward increases the speed of the wipers through the various delay settings, then to LO and HI.
Rotating the control dial toward you (clockwise) causes the wipers to slow down. Rotating the control dial clockwise as far as it will go turns the wipers off.
The windshield washers are operated by a yellow button at the end of the turn signal lever. To operate the washers, press and hold the button in until you want the washers to stop.