Specify the e-mail addresses of other users, one per line
Okay
Cancel
Your session has been submitted.
Your session has been saved.
Failed to submit your session.
Failed to save your session.
All of the information you filled out on this form will be permanently deleted.
Yes, delete my session data.
All of the information you filled out on this form will be permanently deleted.
Finalize and submit this form?
Hide or show technician note textbox.
Required Special Tools
Recommended Shop Tools
You may have invalid TechLane data. We recommend refreshing the page. If you continue to see this, please contact your administrator. Would you like us to refresh the page for you?
No form data to submit.
Failed to save your favorites change. Please try again later. If you continue to see this message. Please contact your administrator.
We are unable to create your session at this time. Please try refreshing your page. If you continue to see this error, please contact your administrator.
Chapter
Error saving form data. Try refreshing your page, and if the issue persists, please contact your administrator.
XXXX-XX-XX
XXXX-XX-XX
Inspection of the Tie Rod End
P4 MM 33.02, 5th Generation Cascadia MM
Inspect the tie-rod ends as follows:
Shake the cross-tube. A loose fit, or movement between
the tapered shaft of the ball and the cross-tube socket members indicates
that the tie-rod end assembly must be replaced.
The threaded portion of the tie-rod end assembly must be
inserted all the way into the cross-tube split for adequate clamping.
See Fig. . Replace the components if
this cannot be done. For instructions,
refer to General Information, Alignment of the Front Axle in
the New Cascadia™ Workshop Manual.
Note: Shown without pinch bolt to provide clarity.
Note: Shown without pinch bolt to provide clarity.