Replacement of the LED Headlamp

47x 20.04.000

Light-emitting diode (LED) headlights must be replaced as an assembly. No part of the assembly can be individually replaced.

  1. Unlatch and open the hood.
  2. Remove the four nuts holding the headlight assembly in place. See Fig..

    1. Nut

    2. Fasteners

    Fig. 1, Remove the Headlight Assembly Fasteners

    3. Note: Do not disconnect the electrical connector before removing the headlight assembly.

  3. Remove the headlight assembly. See Fig..

    1. Headlight Assembly

    2. Four Integral Fasteners

    3. Electrical Connector

    Fig. 2, Headlight Assembly Removed and Disconnected

    4. Note: Headlamp connectors have been redesigned to be more resistant to leaks and may be more difficult to disconnect.

  4. Squeeze the connector lock and slide the red locking tab down to disconnect the electrical connector. Discard the headlamp assembly.
  5. Connect the electrical connector to the new headlight assembly and slide the red locking tab up.
  6. Position the new headlamp assembly in the vehicle hood. Tighten the bolts to 66 lbf·in (745±100 N·cm)
  7. Close and latch the hood.
  8. Clean the headlight lens.
  9. Check the headlight aim.
Note:
Parent topic: Headlights
Document Number: 0000117251
Manual Publication Date: 2024-05-09
Topic Publication Date: 2024-05-09