Federal Motor Vehicle Safety Standard Label

SD DM 00.01.01

Tractors with or without fifth wheels purchased in the U.S. are marked as certified by means of an FMVSS certification label. See Fig.. This label is attached to the driver-side B-pillar as shown in Fig..

Fig. 1, Vehicle Certification Label

  1. Customer Assistance Label

  2. FMVSS Certification Label

  3. Noise Emission Label

  4. Entry/Exit Warning Label

Fig. 2, 122SD and Coronado Driver Door Frame Labels

The tire and rim portion of the FMVSS certification label certifies suitable tire and rim combinations that can be installed on the vehicle for the given gross axle weight rating. Tires and rims installed on the vehicle at the time of manufacture may have a higher load capacity than that certified by the tire and rim label. If the tires and rims currently on the vehicle have a lower load capacity than that shown on the tire and rim label, then the tires and rims determine the load limitations on each of the axles.

Trucks built without a cargo body that are intended for service in the U.S. have an incomplete vehicle certification label attached by the final-stage manufacturer. This label will be attached to the incomplete vehicle document included with the vehicle, and certifies that the vehicle conforms to all applicable FMVSS regulations in effect on the date of completion.

Note:
Parent topic:  Vehicle Identification
Document Number: 0000122536
Manual Publication Date: 2025-01-23
Topic Publication Date: 2025-01-23