Dash Controls
The wipers are operated by a double-paddle WIPER/WASH switch mounted on the main dash panel. The top paddle, when pushed in, turns the wipers on (if they are off) or off (if they are on). When it is pushed up, the top paddle switches the wipers to high speed; when it is pushed down, it switches them to low speed. See Fig..
-
Push in to turn wipers on (low speed) or off.
-
Push up for high speed.
-
Push down for low speed.
-
Push in momentarily for mist cycle. Push in and hold in for wash cycle.
-
Push up for fast delay. If already in delay, push up for the next faster delay.
-
Push down for slow delay. If already in delay, push down for the next slower delay.
-
Locking Clip
-
Wiper/Washer Switch
-
Light Bulb Screw
Fig. 1, Wiper/Washer Switch Operation
The bottom paddle, when pushed in, turns the washers on. When pressed for less than 1/2-second, the wipers will perform a single, low speed dry wipe (mist function). When pressed for more than 1/2-second, the wash cycle begins and continues for three cycles or until the paddle is released. When the bottom paddle is pushed up, the wipers operate in fast delay. When the bottom paddle is pushed down, the wipers operate in slow delay. With the wipers in delay mode (fast or slow), push the bottom paddle up to shorten the delay period or push the paddle down to lengthen it.
Notice: Do not move the wiper arms manually. Wiper motor damage will occur if the arms are moved.