Inspection of the Charge Port, Electric Vehicle

wv mm 54.06.000

Verify that there is no debris around the charge port. Connect a battery charging dispenser to the vehicle charge port and verify that the charge port functions correctly.

    Important: The following battery charging instructions are used with the Proterra battery charging dispenser. If another battery charging dispenser is used, refer to the manufacturer's instructions to charge the vehicle batteries.

  1. Park the vehicle near the charging dispenser, turn the ignition key to the OFF position, and set the parking brake.

    2. Note: The battery disconnect switch is located inside the battery box on the side-wall.

  2. Ensure that the battery disconnect switch is in the ON position. The disconnect switch must be in the ON position in order to charge the batteries.
  3. Open the charge port door, located behind the entrance door. See Fig..
  4. Plug the power feed connector into the charge port. Push hard until a 'click' sound is made. See Fig..

    1. Charge Port

    2. Red LED - indicates a problem with the charger connection.

    3. Green LED - flashes when charging; remains solid when charging is complete.

    4. End Charge Button - press when charging is complete.

    5. Charge Port Door

    Fig. 1, Vehicle Charge Port

    1. Power Feed Connector

    2. Charge Port

    Fig. 2, Plugging the Power Feed Connector into the Charge Port

  5. The green lamp above the charge port will begin to flash, indicating the batteries are being charged. Wait 2 to 5 minutes, then verify that the lamp continues to flash.
    After this time, the inspection is complete; you can go to the remaining steps to end the charging session and disconnect the power feed connector. The vehicle batteries do not need to be fully charged to complete this inspection.
  6. The charging dispenser has a lamp to indicate the charging status. See Table..
  7. Once battery charging is complete, or to end a charging session, press the end charge button either on the vehicle charging port, shown in Fig., item 2, or on the charging dispenser, shown in Fig., item 3, then wait 15 seconds.
  8. After waiting 15 seconds, ensure that the green lamp above the charge port is flashing rapidly. Then press the release button to disconnect the power feed connector. See Fig..

    Table 1, Charging Dispenser Lamp Legend

    Lamp Color

    Description

    White

    Available to charge the vehicle.

    Green (communication)

    Solid - charging dispenser is plugged up but not communicating with the vehicle.

    Flashing - charging dispenser is communicating with the vehicle.

    Blue (charging)

    Flashing - batteries are being charged.

    Solid - batteries charged to 100% capacity.

    Red

    Out of service.

      Table 1, Charging Dispenser Lamp Legend

      1. Charge Dispenser Status Lamp

      2. E-Stop Button (for emergency only)

      3. End Charge Button

      Fig. 3, Charging Dispenser

      1. Release Button

      2. Charge Port

      Fig. 4, Removing the Power Feed Connector

    Note:
    Parent topic: Electrical, Instruments, and Controls
    Document Number: 0000116942
    Manual Publication Date: 2024-05-14
    Topic Publication Date: 2024-11-19