Specify the e-mail addresses of other users, one per line
Okay
Cancel
Your session has been submitted.
Your session has been saved.
Failed to submit your session.
Failed to save your session.
All of the information you filled out on this form will be permanently deleted.
Yes, delete my session data.
All of the information you filled out on this form will be permanently deleted.
Finalize and submit this form?
Hide or show technician note textbox.
Required Special Tools
Recommended Shop Tools
You may have invalid TechLane data. We recommend refreshing the page. If you continue to see this, please contact your administrator. Would you like us to refresh the page for you?
No form data to submit.
Failed to save your favorites change. Please try again later. If you continue to see this message. Please contact your administrator.
We are unable to create your session at this time. Please try refreshing your page. If you continue to see this error, please contact your administrator.
Chapter
Error saving form data. Try refreshing your page, and if the issue persists, please contact your administrator.
XXXX-XX-XX
XXXX-XX-XX
Preliminary Checks
sb mm 83.02.001
Park the vehicle on a level surface, shut down the engine,
apply the parking brake, and chock the tires.
Make sure that the refrigerant compressor drive belt is
not damaged and that it is correctly tensioned. Also check the tightness
of the compressor mounting fasteners. For instructions and torque
values, see General Information, Cummins ISB Series Engine of the Shuttle Bus
Chassis Workshop Manual, or take the vehicle to an authorized
Freightliner dealer.
Using a feeler gauge, check for correct clutch clearance.
For instructions, see of the Shuttle Bus Chassis Workshop Manual, or
take the vehicle to an authorized Freightliner dealer.
Inspect the compressor clutch coil wire. Check the connector
for damage or looseness. Replace the wire if it is damaged.
Check for broken, burst, or cut hoses. Also check for loose
fittings on all parts.
Warning: Wear eye protection when using compressed
air to clean parts, as permanent harm to eyes could result from flying
debris.
Check for a build-up of road debris on the condenser fins.
Using a whiskbroom and air pressure, or a spray of soapy water, carefully
clean off the condenser; be careful not to bend the fins.