Specify the e-mail addresses of other users, one per line
Okay
Cancel
Your session has been submitted.
Your session has been saved.
Failed to submit your session.
Failed to save your session.
All of the information you filled out on this form will be permanently deleted.
Yes, delete my session data.
All of the information you filled out on this form will be permanently deleted.
Finalize and submit this form?
Hide or show technician note textbox.
Required Special Tools
Recommended Shop Tools
You may have invalid TechLane data. We recommend refreshing the page. If you continue to see this, please contact your administrator. Would you like us to refresh the page for you?
No form data to submit.
Failed to save your favorites change. Please try again later. If you continue to see this message. Please contact your administrator.
We are unable to create your session at this time. Please try refreshing your page. If you continue to see this error, please contact your administrator.
Chapter
Error saving form data. Try refreshing your page, and if the issue persists, please contact your administrator.
Pump multipurpose chassis grease (NLGI Grade 1 or 2) into the chamber
bracket until it appears at the slack adjuster end of the bracket.
See Fig.. Use care that
no grease enters the drum cavity. If grease leaks out under the camhead,
the camshaft grease seal is worn or damaged, or is installed backwards.
Note: The use of meter-type fittings, having a maximum
40 psi (276 kPa) pressure relief at shutoff, is recommended.