Starting the Engine

Starting the Engine - Ops
  1. Place the transmission in neutral, and set the parking brake.
  2. Turn on the ignition switch.
    Note: To prevent serious starter motor damage, release the ignition switch immediately after the engine has started.
  3. Wait for the engine system indicator lights on the instrument panel to go out.
  4. With foot off the accelerator pedal, start the engine.
  5. If the engine does not start after 20 seconds, stop. Try again after waiting about 60 seconds.
  6. Monitor the oil pressure gauge immediately after starting the engine.
    Note: Do not increase engine speed if the oil pressure gauge indicates no oil pressure. Shut down the engine within approximately ten seconds to avoid engine damage. Check to determine the cause of the problem.
    Note: Do not place the engine under full load until it reaches operating temperature. Colder engine temperatures will cause the engine to preset idle up to 900 rpm. Even at a high idle condition, you do not have to wait for engine warm up and return to normal 600 rpm idle to drive the truck.
Parent topic: First Time Start Preparations