Detroit™ Axles

sd mm 33.01.001

    Notice: Use regulated pressure when lubricating the knuckle assemblies, otherwise damage could result to the knuckle caps.

  1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. When lubricating upper and lower knuckle assemblies, do not raise the front axle.
  2. Wipe the fittings clean.
  3. Apply multipurpose chassis grease, NLGI Grade 1 (6% 12-hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12-hydroxy lithium stearate grease), until new grease is seen at the junctions of the axle beam and knuckles. For locations of grease fittings, see Fig.; for grease exit points, see Fig..

    • Upper View, LH Side

    • Lower View, LH Side

    1. Grease Fitting

    Fig. 1, Grease Fittings, Detroit Axles

    Fig. 2, Knuckle Pin Grease Exit Points, Detroit Axles

Note:
Parent topic: Knuckle Pin Lubrication
Document Number: 0000120030
Manual Publication Date: 2024-05-23
Topic Publication Date: 2024-10-30