Windshield Wiper/Washer Controls
Caution: Do not move the wiper arms manually. Wiper motor damage will occur if the arms are moved.
The wipers are operated by a rotary switch in the wiper control dial, which is on the end of the turn signal lever. See Fig.. There are five delay settings, marked on the dial by lines of increasing length, and two steady speed settings, LO and HI.
Note: Rotate the control dial away from you to turn the wipers on, or speed them up.
Rotate the control dial towards you to slow the wipers down, or turn them off.
-
Washer Button
-
OFF Position
-
Delay Positions
-
Wipers On, Low Speed
-
Wipers On, High Speed
Fig. 1, Wiper/Washer Controls
Rotating the control dial forward (in a counterclockwise direction) turns the wipers on. If they are already on, rotating the handle further forward (to a faster speed setting) increases the speed of the wipers through the various delay settings, and to LO and then HI.
Rotating the control dial in the opposite direction (clockwise) causes the wipers to slow down. Rotating the control dial clockwise as far as it will go (to the OFF setting) turns the wipers off.
The washers are operated by a yellow button at the very end of the turn signal lever. To operate the washers, press the button in and hold it in until you want the washers to stop.