Sears Seat

Seat Slide Adjustment

Push the seat slide (fore-and-aft adjustment) lever (see Fig.) all the way to the left and slide the seat forward or backward, as desired. Release the lever to lock the seat in the desired position.

Seat Slide Lever

Seat Cushion Tilt Adjustment

Ride Height Knob

Lumbar Support Lever

Backrest Lever

Fig. 1, Sears Low Profile Seat

Isolator

To engage the isolator (if installed), move the seat slide and isolator lever (see Fig.) all the way to the right. To lock out the isolator, move the isolator lever to the center position.

Note: Armrests are optional.

Lumbar Support Lever

Backrest Lever

Ride Height Knob

Shock Absorber Bracket (ride firmness)

Pin (ride firmness)

Snap Ring (ride firmness)

Seat Slide and Isolator Lever

Seat Cushion Adjustment

Fig. 2, Sears Fleetmaster Seat (with isolator)

Lumbar Support

Move the three-position lumbar support lever upward to increase lumbar support (firmer). Move the lever downward to decrease lumbar support (less firm).

For seats with air support, use the aft rocker switch on the control panel on the left-hand side of the seat (see Fig.). Press up to make the seat firmer; press down to make the seat less firm.

Ride Height Switch

Air Lumbar Support Switch

Fig. 3, Air Controls, Sears Seat

Seat Cushion Tilt

To raise the seat cushion, lift upward on the front of the seat cushion, and then push it rearwards. To lower the seat cushion, pull forward on the front of the seat cushion, and then push downwards.

Backrest Adjustment

To adjust the backrest, push downwards on the backrest lever just below the bottom of the backrest cushion. With the lever down, lean forward or backward to the desired position. Release the lever to lock the backrest in place.

Ride Height Adjustment

Push the ride height knob inwards to inflate the air cylinder, raising the height of the seat. Pull the ride height knob outwards to deflate the air cylinder, lowering the height of the seat.

For seats with air support, use the forward rocker switch on the control panel on the left-hand side of the seat (see Fig.). Press up to raise the seat; press down to lower the seat.

Ride Firmness Adjustment

For a softer ride, remove the snap ring and pin from the shock absorber bracket (see inset). Relocate the pin in the other set of holes in the bracket and secure it with the snap ring.