DDE S60

cen dm 07.03.006

    Note: Before doing these steps, do the steps in "Prestart".

  1. Turn the ignition switch to the on position (see Fig.). All the electronic gauges on the ICU (instrumentation control unit) complete a full sweep of their dials, the warning and indicator lights light up, and the buzzer sounds for three seconds.

    Fig. 1, Ignition Switch Positions

  2. When all the indicators go out, turn the ignition switch to the start position. Without touching the throttle pedal, start the engine. If the engine won't start within 15 seconds, release the ignition switch and allow the starter motor to cool.
  3. Check the oil pressure gauge immediately after starting the engine.
  4. If no pressure registers within 10 to 15 seconds or the ENGINE PROTECT indicator comes on, shut down the engine and check the lubricating oil system.

    5. Caution: Protect the turbocharger during the start-up by not opening the throttle or accelerating the engine above 1000 rpm until minimum engine idle oil pressure of 12 psi (83 kPa) registers on the gauge.

  5. Idle the engine for about five minutes at 1000 rpm before operating the engine under load.
Note:
Parent topic: Normal Starting
Document Number: 0000118063
Manual Publication Date: 2024-05-13
Topic Publication Date: 2024-06-06