Windshield Wiper/Washer Controls

The wipers are operated by a rotary switch in the wiper control dial, located on the end of the turn signal lever. See Fig.. There are five delay settings, marked on the dial by lines of increasing length, and two steady speed settings, LO and HI.

Rotating the control dial forward (in a counterclockwise direction) turns the wipers on. If they are already on, rotating the handle further forward increases the speed of the wipers through the various delay settings, and to the LO and HI settings.

Rotating the control dial in the opposite direction (clockwise) reduces the speed of the wipers. Rotating the control dial clockwise as far as it will go (to the OFF setting) turns the wipers off.

The washers are operated by a button at the very end of the turn signal lever. To operate the washers, press the button in and hold it.

Note: Rotate the control dial forward to turn the wipers on, or increase their speed.

Rotate the control dial backward to decrease the wipers speed, or turn them off.

Washer Button

OFF Position

Delay Positions

Wipers On, Low Speed

Wipers On, High Speed

Fig. 1, Wiper/Washer Controls