Specify the e-mail addresses of other users, one per line
Okay
Cancel
Your session has been submitted.
Your session has been saved.
Failed to submit your session.
Failed to save your session.
All of the information you filled out on this form will be permanently deleted.
Yes, delete my session data.
All of the information you filled out on this form will be permanently deleted.
Finalize and submit this form?
Hide or show technician note textbox.
Required Special Tools
Recommended Shop Tools
You may have invalid TechLane data. We recommend refreshing the page. If you continue to see this, please contact your administrator. Would you like us to refresh the page for you?
No form data to submit.
Failed to save your favorites change. Please try again later. If you continue to see this message. Please contact your administrator.
We are unable to create your session at this time. Please try refreshing your page. If you continue to see this error, please contact your administrator.
Chapter
Error saving form data. Try refreshing your page, and if the issue persists, please contact your administrator.
XXXX-XX-XX
XXXX-XX-XX
General Information
s2 dm 19.03.000
Note: Before starting the engine, read the "Ametek
Panel" information in this chapter and Ignition Switch and Key for detailed
information on how to read the instruments and operate the controls.
Notice: If a vehicle does not
start on the first attempt, make sure that the engine has completely
stopped rotating before reapplying the starter switch. Failure to
do so can cause the pinion to release and re-engage, which could cause
ring gear and starter pinion damage.
Moving a vehicle with
the starter and/or using the starter to bump the engine for maintenance
procedures is strictly prohibited. Use of these methods to bump the
engine over or move the vehicle can cause the pinion to release and
re-engage, which could cause ring gear and starter pinion damage.