Specify the e-mail addresses of other users, one per line
Okay
Cancel
Your session has been submitted.
Your session has been saved.
Failed to submit your session.
Failed to save your session.
All of the information you filled out on this form will be permanently deleted.
Yes, delete my session data.
All of the information you filled out on this form will be permanently deleted.
Finalize and submit this form?
Hide or show technician note textbox.
Required Special Tools
Recommended Shop Tools
You may have invalid TechLane data. We recommend refreshing the page. If you continue to see this, please contact your administrator. Would you like us to refresh the page for you?
No form data to submit.
Failed to save your favorites change. Please try again later. If you continue to see this message. Please contact your administrator.
We are unable to create your session at this time. Please try refreshing your page. If you continue to see this error, please contact your administrator.
Chapter
Error saving form data. Try refreshing your page, and if the issue persists, please contact your administrator.
XXXX-XX-XX
XXXX-XX-XX
General Information
s2 m 26.04.000
Important: For oil and filter change intervals, see
the applicable Allison Operator's Manual.
For Allison Transmission Operators Manual and Warranty Information
for on-highway vehicle applications, visit www.allisontransmission.com/my-allison/customer or scan the QR code. See Fig. .
Fig. 1,
Allison Transmission QR Code
When draining transmission fluid, check for evidence of dirt or
water contamination. A small amount of condensation will appear in
the fluid during operation.
Water contamination is normally characterized as a milky discoloration
of the transmission fluid. Obvious contamination of the transmission
fluid indicates a leak between the water and fluid areas of the transmission
cooler. Inspect and pressure-test the cooler to confirm the leak;
replace leaking transmission coolers.