Removal from Storage

Follow these steps when the recreational vehicle is removed from storage.

• Remove the covers from the tires and thoroughly inspect the tires for damage. Inflate them to the correct pressure for the actual weight on the tires. Consult the Michelin or Goodyear manual included with your chassis for correct tire pressure. Weigh the vehicle if you do not know how much it weighs.

• Check for fluid leaks. Repair as necessary.

• Change the engine oil and filter after extended storage.

• Check the coolant level in the reservoir and radiator. Add coolant if needed.

• Check the hydraulic fluid level in the reservoir. Add fluid if needed.

• Check the engine belts for wear, damage, or cracking.

• Check the engine fan for damage.

• Check the fuel/water separator. If it is empty, prime the fuel system. For Cummins engine service literature, refer to the Cummins Online website at or scan the QR code. See Fig.. For Detroit™ engine service literature, refer to the Detroit Diesel link on the DTNA TechLit website or scan the QR code. See Fig..

• Check the engine compartment for nesting animals. Check for leaks and damage to the hoses and wiring.

• Check the rear axle lubricant level.

• Lubricate all grease fittings on the chassis and drivetrain.

• Check the charge level of the battery. Clean the ends of the battery cables. If the batteries need to be replaced, install a clean and fully charged battery. Always connect the positive cable first, then connect the negative cable. Coat the battery terminals and connectors with a dielectric protectant sealant.

• If the vehicle was stored on safety stands, lower the vehicle at this time and set the parking brake.

• Turn the ignition to the RUN position. Verify that the fuel gauge and voltmeter are working correctly.

• Run the engine until it is warm, then check again for fluid leaks.

• Check the transmission fluid level using the cold check method in the Allison Operator's Manual .

• Check all exterior lights and replace as necessary.