Ignition Sequence
When the ignition is turned on, OptiView performs a self-test. Observing the ignition sequence is a good way to ensure the OptiView panel is functioning properly.
Important: Do not crank the engine until the OptiView self-check is complete.
-
When the ignition is in the ON position, the following actions should occur:
-
warning and indicator lamps illuminate for approximately three seconds, then are extinguished;
-
seatbelt indicator lamp remains on for an additional five seconds after the other indicator lamps are extinguished;
-
audible alarm sounds until the self-test is completed;
-
if any faults are detected, an error message will display in the menu area of the instrument panel.
When the self-test is complete, all warning lamps and indicators are extinguished.