Programming a New Smart Key Fob
rv dm 05.01.002
Note: A maximum of two smart key fobs can be programmed for a vehicle. In the event that all registered smart key fobs are not available or are damaged, the dealership must perform a service routine to program a new smart key fob.
In order to program a new smart key fob for the vehicle, the ignition must be in the ON position, vehicle speed must be under 3 mph (5 km/h), and at least one registered smart key fob (for that vehicle) must be available. Follow the steps below to program the new smart key fob.
- Activate the vehicle ignition system. See the "ON" section under the "Push-Button Ignition and Smart Key Fob" heading.
- Using the instrument cluster, navigate to the 'Vehicle Configuration' menu. Enable fob programming in this menu. For navigation instructions, see General Description or General Information as applicable to the instrument cluster installed in the vehicle.
- Press and hold the front entry door lock button (approximately three seconds) of the registered smart key fob until the instrument cluster displays 'Programming Mode Active'.
- Press and hold the front entry door lock button (approximately three seconds) of the unregistered (new) smart key fob until the instrument cluster chimes once. The new smart key fob is now registered to the vehicle.
- Press the service brake pedal or the START/STOP ENGINE button once to exit programming mode.
Note: Do not depress the service brake pedal when performing the next two steps.
Note: