Manual Uncoupling
4700 d 18.03.000
- Set the tractor and trailer parking brakes.
- Chock the trailer rear wheels.
- Lower the trailer landing gear until the weight is removed from the fifth wheel.
- Disconnect the tractor-to-trailer air system lines and electrical cable. Plug the air lines to prevent dirt or foreign material from entering the lines.
- Verify that both the parking brake and trailer air supply knobs are out (see Fig.), the tractor and trailer parking brakes are set, and that the trailer is prepared for uncoupling.
- Release the kingpin locking mechanism following the instructions
for each manufacturer below.
- Fontaine: Lift the safety latch and pull the lock control handle to the unlocked position. See Fig..
- Holland: In the locked position the safety indicator
swings freely over the operating rod. See Fig., View A. To unlock the mechanism, manually rotate the safety indicator toward the rear of the fifth wheel. See Fig., View B.Pull the operating rod out. When the upper operating rod shoulder is outside the slot, raise the handle and place the shoulder of the upper rod against the plate casting, above the slot. See Fig., View C.The fifth wheel is now in the lockset position and is ready for uncoupling. As the tractor pulls away from the trailer the kingpin forces the jaw to rotate, contacting the lock. Continued rotation of the jaw forces the lock to move outward, and drops the upper rod back into the slot. See Fig. View D. The wheel is now ready for coupling.
- Jost: Pull the retractable handle out, then secure it in the open position with the catch. See Fig..
- Release the tractor parking brake then drive out slowly, allowing the trailer to slide down the fifth wheel and pick-up ramps.
Note: