Seat Belt Operation
Three-Point Seat Belt
Note: For vehicles equipped with the Komfort Latch or the Sliding Komfort Latch, see the seat belt operation under the heading Seat Belt With Komfort Latch or Sliding Komfort Latch .
Warning: Wear three-point seat belts only as described below. Three-point seat belts are designed to be worn by one person at a time. In case of an accident or sudden stop, personal injury or death could result from misuse.
Fasten the seat belts before driving. Fastening a three-point seat belt while driving creates a hazard.
- Slowly pull the link end of the three-point seat belt out of the retractor and pull it across your lap (from outboard to inboard) far enough to engage the buckle. If the retractor locks too soon, allow the belt to retract slightly, then slowly pull it out again.
- Fasten the seat belt by pushing the latch into the buckle.
Listen for an audible click. See Fig..
Fig. 1, Fastening the Three-Point Belt
- Tug on the seat belt to make sure it is securely fastened. If the buckle unlatches, repeat this step. If the problem continues, replace the seat belt.
- Snug the seat belt to your waist.
- Position the shoulder strap diagonally across your chest
with the adjustable D-loop bracket (if equipped). The shoulder strap
must be centered on your shoulder and chest, away from your face and
neck. See Fig..
-
Correct—Belt is centered on your shoulder and chest, away from your face and neck.
-
Wrong—Belt must not rub against face or neck.
-
Wrong—Belt must not hang off shoulder.
Fig. 2, Proper Shoulder Strap Fit
-
- To unbuckle the seat belt, press the release button on
the buckle. See Fig..
Fig. 3, Releasing the Three-Point Seat Belt
Note: Make sure the seat belt is completely retracted when it is not in use.