Hendrickson

cen mm 32.02.000

The Hendrickson RS Series suspension does not require lubrication.

For Hendrickson RT2 and RTE2 Series, lubricate the bronze, ball-indented bushings in the spring eye, as follows:

  1. Park the vehicle on a level surface, apply the parking brakes, and chock the front tires.
  2. Raise the rear of the vehicle until the rear wheels are suspended in the air, then support the vehicle with safety stands. This relieves the load on the bushings and pins to allow the proper flow of lubricant around them.
  3. Use a multipurpose chassis grease and lubricate the bronze, ball-indented bushings in the spring eyes at the grease fitting. See Fig.. Continue to lubricate until grease exits both ends of the bushing. If the pin will not accept lubricant, remove the pin and clean the lubrication channels where lubricant may have hardened. Remove the safety stands and lower the vehicle after lubrication is complete.

    1. Bronze Bushing

    2. Lubrication Hole

    3. Grease Fitting

    4. Lubrication Groove

    Fig. 1, Hendrickson RT2 and RTE2 Series Bushing Lubrication

Note:
Parent topic: Freightliner Spring
Document Number: 0000122123
Manual Publication Date: 2025-02-11
Topic Publication Date: 2024-06-04