General Description

cen mm 49.01.000

In addition to inspecting the exhaust system at the scheduled maintenance interval, inspect the exhaust system if the noise level of the vehicle has increased. Replace parts that show leakage, wear, or damage, with genuine Freightliner parts.

Important: The Environmental Protection Agency's 2007 regulations require lower exhaust emissions, thus requiring new exhaust system components. See Fig.. In particular the after-treatment device (ATD), which is part of the after-treatment system (ATS), requires special attention during regularly scheduled maintenance inspections. If any discrepancies are discovered, refer to the engine manufacturer's service literature for repair instructions.

  • Inspect this area of the canister for dents.

  1. Marmon Fitting at Inlet from Turbocharger

  2. DOC Temperature Sensor

  3. ATD Mounting Band

  4. DPF Intake Pressure Sensor

  5. DPF V-Band Mounting Clamps

  6. Sensor Housing

  7. DPF Outlet Temperature Sensor

  8. Exhaust Outlet Marmon Fitting

  9. DPF Outlet Pressure Sensor

Fig. 1, Typical After-Treatment Device

Note:
Parent topic: Inspecting of the EPA07 Exhaust System
Document Number: 0000122433
Manual Publication Date: 2025-02-11
Topic Publication Date: 2024-06-04