Lubrication of the Meritor Slack Adjuster

cen mm 42.08.000

Important: Perform MOP Parking Brake Operational Check before lubricating the slack adjusters.

Note: If equipped with an extended-maintenance Q Plus™ brake system, the slack adjuster will not have a grease fitting. These slack adjusters use a special NLGI Grade synthetic polyurea grease and do not require lubrication for 3 years or 500,000 miles (800 000 km), whichever comes first. The extended-maintenance slack adjusters are lubricated during the brake reline service interval. For service and lubrication instructions, see of the Century Class Trucks Workshop Manual.

For slack adjusters with grease fittings, and for operating temperatures above –40°F (–40°C), use a NLGI Grade 1 clay-base grease or a NLGI Grade 1 or 2 lithium-base grease.

For slack adjusters with grease fittings, and for operating temperatures below –40°F (–40°C) and above –65°F (–54°C), use a NLGI Grade 2 synthetic oil, clay-base grease.

Lubricate the slack adjuster at the grease fitting until grease is forced past the pressure-relief capscrew, or past the gear splines around the inboard snap ring. See Fig..

  1. Brake Chamber

  2. Clevis

  3. Actuator Rod

  4. Boot

  5. Pressure-Relief Capscrew, Gasket, Pawl Spring, and Pawl

  6. Manual Adjusting Nut

  7. Grease Fitting (or plug)

Fig. 1, Meritor Automatic Slack Adjuster

Note:
Parent topic: Brakes
Document Number: 0000122413
Manual Publication Date: 2025-02-11
Topic Publication Date: 2024-06-04