High Idle with Cruise Control

wv dm 06.03.001

Note: To operate the high idle options listed below, the vehicle must be stopped, the transmission shift lever placed in the Neutral (N) or Park (P) position, and the parking brake set.

Important: Do not idle the engine for excessively long periods. The extreme heat may cause the bearings to seize or the oil seals to leak.

  1. Place the shift lever in Neutral (N) or Park (P) and set the parking brake.
  2. Press the cruise switch located on the dash to the ON position. Press the RESUME switch to accelerate the engine revolutions per minute (rpm) to the minimum set speed. To increase the engine rpm, press and hold the RESUME switch. To decrease the engine rpm, press and hold the SET switch.

    3. Note: The rpm can also be increased by depressing the throttle pedal until the desired rpm is met, and then pressing the SET switch.

  3. Disengage the cruise control by depressing the service brake pedal, or by moving the ON/OFF switch to the OFF position.
Note:
Parent topic: High Idle Options
Document Number: 0000071474
Manual Publication Date: 2024-03-26
Topic Publication Date: 2024-03-26