Sears Atlas II Deluxe High Back Seat

ep3 dm 7.07

For seat adjustment controls, see Fig..

  1. Armrest Adjustment Knob

  2. Backrest Tilt Handle

  3. Lumbar Support Switches

  4. Suspension Inflation/Deflation Switch

  5. Isolator Lever

  6. Slider Bar

  7. Seat Extension Handle

Fig. 1, Sears Atlas II Deluxe High Back Seat

  1. Armrest Adjustment Knob: While sitting in the seat, rotate the knob underneath the armrest counter-clockwise to tilt the armrest up, or clockwise to tilt the armrest down.
  2. Backrest Tilt Handle: Pull upward on the recliner handle, then lean forward or rearward to move the backrest to the desired position. Release the handle to lock in the backrest angle.
  3. Lumbar Support Switches:
    Rear rocker switch : Push forward and hold to inflate the upper lumbar pillow; push rearward and hold to deflate the pillow.
    Center rocker switch : Push forward and hold to inflate the lower lumbar pillow; push rearward and hold to deflate the pillow.
  4. Suspension Inflation/Deflation Switch: Push and hold the grey rocker switch forward to inflate and raise the seat suspension; push and hold the switch rearward to deflate and lower the seat suspension.
  5. Isolator Lever: Move the isolator lever to the left to allow for isolation movement. Position the handle to the right to lock out isolation movement.
  6. Slider Bar: Pull up on the slider bar and slide the seat forward or rearward. Release the bar to lock the seat into position. The seat can move 9 inches (23 cm).
  7. Seat Extension Handle: With weight off the seat, lift the seat cushion to release it. Facing the seat, rotate the handle under the front right corner of the seat up and hold it as you pull or push the seat cushion into the desired position. Release the handle to lock the seat in place. Three positions are available.
Note:
Parent topic: Seats and Restraints
Document Number: 0000087446
Manual Publication Date: 2024-03-21
Topic Publication Date: 2025-02-13