Anti-Roll-Away Feature
The Intellipark anti-roll-away feature is intended to mitigate the possibility of a roll-away resulting from the driver failing to set the parking brake. Anti-roll-away automatically sets the parking brake within three seconds in the following circumstances.
-
The engine is turned off and the park brake was not set prior.
-
The vehicle is stationary, the accelerator pedal is not pressed, and the foot brake is not applied.
-
The driver's door is opened and the speed is less than 3 mph (5 km/h).
Both LEDs in the yellow control blink continuously until the mitigation is acknowledged. To acknowledge, pull out on the bottom of the parking brake control.
Important: The parking brake can not be released until the anti-roll-away mitigation has been acknowledged.
Release the parking brake by depressing the foot brake and pushing the bottom of the parking brake control. See Fig. for the sequence of actions required.
-
Blinking LEDs indicate an anti-roll-away mitigation event.
-
To acknowledge, pull out the bottom of the control.
-
To release the parking brake, press the foot brake, then push the bottom of the parking brake control.