Sears C-2 Plus Seat
Seat Slide Adjustment
Note: The seat should only be adjusted when the vehicle is parked with the park brake on.
Push the seat slide (forward/back adjustment) lever shown in Fig. all the way to the left and slide the seat forward or backward, as desired. Release the lever to lock the seat in the desired position.
-
Seat Slide Lever
-
Seat Cushion Tilt Adjustment
-
Ride Height Knob
-
Lumbar Support Lever
-
Backrest Lever
Fig. 1, Sears Low Profile Seat
Isolator
To engage the isolator (if installed), move the seat slide and isolator lever, as shown in Fig., all the way to the right. To lock out the isolator, move the isolator lever to the center position.
Note: Armrests are optional.
-
Lumbar Support Lever
-
Backrest Lever
-
Ride Height Knob
-
Shock Absorber Bracket (ride firmness)
-
Pin (ride firmness)
-
Snap Ring (ride firmness)
-
Seat Slide and Isolator Lever
-
Seat Cushion Adjustment
Fig. 2, Sears Fleetmaster Seat (with isolator)
Lumbar Support
Move the three-position lumbar support lever upward to increase lumbar support (firmer). Move the lever downward to decrease lumbar support (less firm).
Note: This three-position lever (see inset) does not rotate a full 360 degrees.
For seats with air support, use the aft rocker switch on the control panel on the left-hand side of the seat, shown in Fig.. Press up to make the seat firmer; press down to make the seat less firm.
Seat Cushion Tilt
To raise the seat cushion, lift upward on the front of the seat cushion, and then push it rearwards. To lower the seat cushion, pull forward on the front of the seat cushion, and then push downwards.
Backrest Adjustment
To adjust the backrest, push downwards on the backrest lever just below the bottom of the backrest cushion. With the lever down, lean forward or backward to the desired position. Release the lever to lock the backrest in place.
Ride Height Adjustment
Push the ride height knob inwards to inflate the air cylinder, raising the height of the seat. Pull the ride height knob outwards to deflate the air cylinder, lowering the height of the seat.
For seats with air support, use the forward rocker switch on the control panel on the left-hand side of the seat as shown in . Press up to raise the seat; press down to lower the seat.
Ride Firmness Adjustment
For a softer ride, remove the snap ring and pin from the shock absorber bracket (see inset). Relocate the pin in the other set of holes in the bracket and secure it with the snap ring.