Sears C-2 Plus Seat

Seat Slide Adjustment

Push the seat slide (forward/back adjustment) lever shown in Fig. Sears Low Profile Seat all the way to the left and slide the seat forward or backward, as desired. Release the lever to lock the seat in the desired position.

Sears Low Profile Seat

1. Seat Slide Lever

2. Seat Cushion Tilt Adjustment

3. Ride Height Knob

4. Lumbar Support Lever

5. Backrest Lever

Isolator

To engage the isolator (if installed), move the seat slide and isolator lever, as shown in Fig. Sears Fleetmaster Seat (with isolator), all the way to the right. To lock out the isolator, move the isolator lever to the center position.

Sears Fleetmaster Seat (with isolator)

Note:  Armrests are optional.

1. Lumbar Support Lever

2. Backrest Lever

3. Ride Height Knob

4. Shock Absorber Bracket (ride firmness)

5. Pin (ride firmness)

6. Snap Ring (ride firmness)

7. Seat Slide and Isolator Lever

8. Seat Cushion Adjustment

Lumbar Support

Move the three-position lumbar support lever upward to increase lumbar support (firmer). Move the lever downward to decrease lumbar support (less firm).

For seats with air support, use the aft rocker switch on the control panel on the left-hand side of the seat, shown in Fig. Air Controls, Sears Seat. Press up to make the seat firmer; press down to make the seat less firm.

Air Controls, Sears Seat

1. Ride Height Switch

2. Air Lumbar Support Switch

Seat Cushion Tilt

To raise the seat cushion, lift upward on the front of the seat cushion, and then push it rearwards. To lower the seat cushion, pull forward on the front of the seat cushion, and then push downwards.

Backrest Adjustment

To adjust the backrest, push downwards on the backrest lever just below the bottom of the backrest cushion. With the lever down, lean forward or backward to the desired position. Release the lever to lock the backrest in place.

Ride Height Adjustment

Push the ride height knob inwards to inflate the air cylinder, raising the height of the seat. Pull the ride height knob outwards to deflate the air cylinder, lowering the height of the seat.

For seats with air support, use the forward rocker switch on the control panel on the left-hand side of the seat as shown in Air Controls, Sears Seat. Press up to raise the seat; press down to lower the seat.

Ride Firmness Adjustment

For a softer ride, remove the snap ring and pin from the shock absorber bracket (see inset). Relocate the pin in the other set of holes in the bracket and secure it with the snap ring.